Now we have to glue the boom and body together. The first step is to take the sanding block and sand a slight angle in the back right side of the body.

Then lay the body and boom on the table and overlap them about 1/4".

Use a straightedge to align the body and boom together.

The body should look straight when viewing down it.

Now using a pin, apply small drops of glue around the joint to glue the boom to the body.
As an alternate method you can pick the boom up and place a small drop of superglue where the boom was laying, then reposition the boom back onto the body. If you choose this method, then you must position the boom quickly or the superglue may dry before you have it positioned it correctly.

After the glue has dried, the boom should look like this when viewed from the top. The boom is intentionally offset like this to help the model circle to the left.