Locate
one of the wing posts and place the tissue tube on it. Place a small droplet
of glue on the tissue tube, then position it on the body so that the back
of the tube is in line with the leading edge wing mark (see photo below),
which is 1" for the Division B model. Apply some accelerator and let it
dry for a minute. Be very careful not to get superglue between the wing
post and the tissue tube socket or inside the tissue tube, otherwise the
post will be glued to the tube and you will not be able to pull it out.
Lay the wing on top of the
body, and slide it up so it hits the leading edge wing post. Then take
a pen and mark the trailing edge of the wing on the top of the body.
Extend the line down the
side of the body as shown below. This is the location of the rear wingpost
socket.
Glue the other wingpost/tissue
tube just behind of the line you just created. You want to make sure that
the wingposts are parallel with each other and
not crooked.
This is what it should look
like when you are done. Not like this.
